Traxstech's Single Lift & Turn Rod Holder is a super duty rod holder that comes with various mounting options to offer maximum positioning of your fishing rod. Our single rod holder lifts & rotates every 18 degrees/20 positions for maximum all-around positioning. Adjust the rod holder with just one hand by pulling the tube sideways and then moving it to the next set of teeth. Once in place, release the tube for full engagement and strength of all 20 machined teeth in the side of this holder. Our single rod holder has 6 positions from 0 degrees to 90 degrees and one position past 90 degrees to get the rod tip to the water if desired. We have machined a center hub to prevent lifting when used with Dipsy Divers® on the bottom and side sections. This is an aluminum machined rod holder you will not be disappointed with its strength and flexibility.

Single Lift & Turn Rod Holder Mounting Options

Single Lift & Turn Rod Holder with Base to Slide into Traxstech's Tracks

• Part: #RH1
• Slides in our track system

Single Lift & Turn Rod Holder on a 45 Degree Angle T-bolt Bracket

• Part: #RH1-TBM-45
• Has a TBM-45 bracket on it to go in a 45 degree manufacture track.

Single Lift & Turn Rod Holder on a 50 Degree Angle T-bolt Bracket

• Part: #RH1-TBM-50
• Has a TBM-50 bracket on it to go in a 50 degree manufacture track.

Single Lift & Turn Rod Holder on a 58 Degree Angle T-bolt Bracket

• Part: #RH1-TBM-58
• Has a TBM-58 bracket on it to go in a 58 degree manufacture track.

Single Lift & Turn Rod Holder on a 90 Degree Angle T-bolt Bracket

• Part: #RH1-TBM-90
• Has a TBM-90 bracket on it to go in a 90 degree manufacture track.

Single Lift & Turn Rod Holder on a 90T Degree Angle T-bolt Bracket

• Part: #RH1-TBM-90T
• Has a TBM-90T bracket on it to go in a Tracker brand boat with the manufacturers track.

Single Lift & Turn Rod Holder on ACB Bracket for Alumacraft Boats with the Alumatrac System

• Part: #RH1-ACB-250
• Has a Alumacraft style bracket to fit on the Alumatrac system.

Single Lift & Turn Rod Holder on a Rail Clamp

• Part: #RM-700-RH1
• Has a RM-700 that fits round rails 3/4" to 1-1/4" diameter and 1-1/4" square rails.

Single Lift & Turn Rod Holder on a Rail Clamp

• Part: #RM-800-RH1
• Has a RM-800 that fits round rails 1-1/4" to 2" diameter.

Single Lift & Turn Rod Holder with Base for Scotty Downriggers

• Part: #SCTRH1
• This fits a Scotty Downrigger only.